Model: KT61365
Price: USD195
48v 1000w 150RPM
Gear ratio:1:5
Pole pairs:10
max torque 200N.m
The tire is 13×6.5-6 13 inch tubless fat tire. 48V max torque 200N.m, no load speed 150RPM, reversible. It is ok to run at 24v or 36v battery, but the speed and torque will be lower. Stainless gears inside, gear ratio 1:5. This motor is brushless dc hub motor, it has 3 phase cable and 5 hall sensors wires, and it is ok to add encoder and temperature sensors to the motor.
This high torque low speed hub motor is ok to used in many robots.It is also ok to install other size tires, such us 10×5-6, 12×5-6,145/70-6, 15×6-6, 15×5-6 and so on.
Please advise what load would four of these powered wheel with two per side of a small tug for pulling a 4,000 kg trailer. The tongue weight could be 600 – 800 kg on the tug. Do you have control systems for the four motors with wireless remote controllers? IF four wheels would not do, would it be capable with six tires?
Would love to have all those specs and what the encoder connector is and where to get the match female connector perferably with a cable with male pin leads on the other end to pull intoo a odesc 3.6 controller.
I have 2 of these I’m trying to prototype with and would like to decide soon on large order before tariffs show up.
Do you have the specs on this?
I’m hoping to use this for a large cargo vehicle that will be used on sand. My vehicle has six wheels. Would you please provide me with a spec sheet? I would like to know information like:
-Max load
-Tire PSI
-Current draw at max torque
-All product dimensions
I would also like to know if any of your motor controllers could be used to control six of these, or if I will need to architect my own combination of controllers.
Thank you in advance!
can I get a quote?