reverseble 48V 100N.m 11 inch geared wheelbarrow hub motor

9 Comments

1. I’m looking for a dual shaft geared motor 10-11 inches (with tire) and a max speed of up to 20 km/h for my robot application. Wheelbarrow options are too slow, and gearless scooter wheels don’t provide enough torque. Could you suggest the right option for me? I’ll buy a set of 4.

   Reply

2. Best regards Tony.
   Is it possible to make the same wheel-gear motor, only so that it has a power of 1500 W and a torque of more than 120 N.m
   I look forward to a quick response, thank you very much!

   Reply

   1. the same motor geared, 150N.m MAX is ok.

      Reply

3. Добрый день
   Может быть такой же размер покрышки и посадочные размеры по валу мотор-редуктора только на 1500W и таким же крутящим моментом или больше?
   и можно поставить в Россию

   Reply

4. Best regards Tony.

   For a 4-wheel prototype vehicle with front Ackerman steering: can I install two of these motors on the front wheels and achieve a differential effect? That is, when turning the rudder to the right, the left wheel must rotate more than the right.

   the idea is to have a single throttle or command

   Reply

   1. this depends on your controller

      Reply

5. best regard!

   We want this engine with a minimum speed of 7 km/h.
   I ask you: when selecting that engine does the complete kit come? (controller, controller-motor connection cables, USB cable for programming, motorcycle-type accelerator, disc brake with actuator) If not, please send me the respective links to make the purchase today.

   I look forward to a quick response, thank you very much!

   Reply

6. Sea water submersible and reversable motor and gearbox required

   Reply

   1. It is ok to customize for you.

      Reply